|
 |
|
 Berco, after exaustive experimenting in the shop, is placing at the disposal of all those who are active in the field of track assembly and disassembly, the DCL, a handy and rational group, for vacuum testing of oil seals and for injecting oil into lubricated track joints. the DCL is a self contained group consisting of:
- Vacuum power pump
- Oil power pump with built-in high pressure relief valve
- Universal, single-phase electric control box complete with fuses and overload cutouts
- Control panel with main switch, pushbuttons, pressure gauge and vacuum gauge
- Tank equipped with: cap with filter, oil sight glass and thermometer
- Tank for recovered lubricant
- A special gun, connected to the group by two rubber hoses, complete with nozzle and lever-operated valves, light and handly, equipped with a combined gauge for checking vacuum in track seals and oil pressure as well.
|
|
|
The standard model DCL also comes in the DCL/D version.
This version has been specially designed for the leakage test of the seal groups and for the oil filling of the rollers of the tracked vehicles.
The main differences (in comparison with the DCL model) are the following:
- It is possible to carry out the leakage test even with compressed air (an in-feed of compressed air at 5 to 6 bar is needed)
- Automatic metering of the quantity of oil introduced for each cycle
- It comes with an oil pre-heating system (in order to improve the oil fluidity, thus helping carrying out its introduction) by means of an electric heating element built in the oil tank and of a temperature control thermostat.The standard technical features, as well as size and accessories, are unchanged. |
|
